Spectralink h340 User Manual download pdf (Page 20)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone

with SIP

PN: 72-1089-02-D.doc Page 20

SVP Server IP The IP address of the NetLink SVP Server. If using Static IP

configuration, this is simply the IP address of the NetLink SVP Server. Note that

the NetLink SVP Server must be statically configured to have a permanent IP

address. If DHCP is being used, the handset will try the following, in order: the

DHCP option 151, then a DNS lookup of “SLNKSVP2” if the DHCP options 6

(DNS server) and 15 (Domain Name) are configured.

TFTP Server IP The IP address of a TFTP server on your network, which holds

software images for updating the handsets and contains the handset files. If this

feature is configured (not set to 0.0.0.0 or 255.255.255.255) with either Static IP

configuration or using DHCP option 66 (TFTP server), or the boot server/next

server (siaddr) field, the handset will check for newer software each time it is

powered on or comes back into range of your network. This check takes only a

second and ensures that all handsets in your network are kept up-to-date with the

same version of software.

SIP TFTP Server IP The IP address of a TFTP server on your network, which

holds SIP configuration files. In static mode, this parameter must be configured

with an IP address. In DHCP mode, the SIP TFTP server may be specified by

defining the address on the DNS server for the name “siptftp” If this is not

defined, the address specified in option 66 will be used. See Section 5,

SIP

Integration Factors

Default Gateway and Subnet Mask Used to identify subnets, when using a

complex network, which includes routers. Both of these must be configured

either with an IP address under Static IP (not set to 000.000.000.000 or

255.255.255.255) or with DHCP for the handset to contact any network

components on a different subnet. If configured on the DHCP server, use

option 3 for the Default Gateway and option 1 for the Subnet Mask. Contact the

network administrator for the proper settings for the network.



Note that the wireless telephones cannot “roam” across subnets, since they

cannot change IP addresses while operational. Ensure that all APs are

attached to the same subnet for proper operation. The handset can change

subnets if DHCP is enabled and the handset is powered-off then back on

when within range of APs on the new subnet.

Syslog Server IP The IP address of the syslog server. See the

Diagnostic Tools

section for more information.

OAI Server IP The IP address of the NetLink OAI Gateway. If using Static IP

configuration, this is simply the IP address of the NetLink OAI Gateway. If

DHCP is being used, the handset will try the DHCP option 152.

ESSID

Select the option that will enable the handset to acquire APs with the correct ESSID

(Extended Service Set ID, aka SSID) each time it is turned on.

Note about Automatic Learn options: Broadcast ESSID must be enabled in the APs

for ESSID learning to function. Refer to the

Configuration Note

for specific APs or

call the AP vendor for specifics. Overlapping wireless systems complicate the use of

ESSID learning as the handset in an overlapping area could receive conflicting

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 60 61

Comments to this Manuals

No comments

Spectralink h340 User Manual Page 20

Comments to this Manuals

Related products and manuals for Handset Cordless Phone Spectralink h340