Spectralink h340 User Manual download pdf (Page 12)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone

with SIP

PN: 72-1089-02-D.doc Page 12

PBX via the proxy server if the user selects PBX cadence described in the

User-

defined Preferences

section.

Audio features

Speakerphone features are not available on the e340/h340/i640 handset.

2.8 Startup Sequence

The NetLink Wireless Telephone goes through an initialization sequence at startup.

The line icons 1-9 display and count down as the handset steps through this

sequence. This is usually very rapid. If there is difficulty at any step that prevents

initialization from continuing, an error message will display and the related icon(s)

will stay on. Please see the error table at the back of this document for instructions

on how to handle error messages that occur during initialization.

Icon The icon(s) shown in bold turns off when:

123456789 The handset has located and authenticated and associated with at least one AP, and is proceeding to

bring up higher-layer networking functions.

12345678 The handset is either configured for Static IP, or if configured for DHCP, the DHCP discovery process

has started.

1234567 If DHCP is configured, a DHCP response was received which contains a good DNS server

configuration.

123456 Note: Only valid on non-SRP protocol. Indicates one of the following:

Static IP configuration, or

NetLink SVP Server address found in DHCP response, or

NetLink SVP Server address found via DNS lookup.

12345 All networking functions are complete (notably, DHCP), and the handset is proceeding with

establishing the SRP link to the NetLink SVP Server.

1234 The SRP link is established; all network stack initialization is complete, proceeding with application-

specific initialization.

123 SIP application startup. Icon 3 is extinguished if a generic SIP config file is found.

12 Icon 2 is extinguished if a handset specific SIP config file is found.

(no icons)

Registering

Handset is attempting to register each of the specified line contacts.

(no icons)

EXT. XXXXX

Handset has registered with at least one contact on one proxy server. Initialization is complete. The

handset is in standby mode ready to receive and place calls. The line one contact is displayed.

During the last three steps of this process, the handset contacts the SIP TFTP server

and downloads general information about the proxy server(s), downloads specific

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 60 61

No comments

Spectralink h340 User Manual Page 12